What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 24.06.2025 01:54
This is where the MOV conducts again, and dissipated the energy.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–14 [Omar Gharbi Omar Gharbi ]
What is your craziest college sex story?
Edit 2024–10.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But it can get overloaded, and no longer works.
The MOV will conduct when the voltage exceeds 50% of line voltage.
One
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
nine
a photo is worth a thousand words.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
These devices are installed between the “hot” and “neutral” and protective ground.
But… the neutral is now “floating” because of the 1 ohm resistance.
He then describes Rainy Season and Lightning.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Now when you have a certain ac resistance, then a current flows in a loop.
Angelina Jolie And Brad Pitt’s Daughter Shiloh Reintroduces Herself With New Name - HuffPost
(Dc diagram shown, AC is similar).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The bolt then partially travels down the line to your home.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is 'the assistant's answer'
There are two important concepts here.
A fuse is a non-resetable over current circuit protector.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Why is our generation so unhappy?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
so, what happens?
At least they know the answer if they wanted it.
Woman attacked by rabid cat in Lynchburg, health officials say - WSET
The third is lightning and “how it gets conducted into a home.”
The other is “what does a “fuse” do?”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
BYD unleashes an EV industry reckoning that alarms Beijing - Fortune
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
There are three different concepts here that are getting confused.
What is the story behind bhai dooj?
He then asserts :
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
One is “what exactly is in a ‘surge protector’ ? ”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
[image of Common-mode choke]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
What does a fuse do?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
For this case there are devices called Metal oxide varistors (MOV).
[old diagram got deleted by accident]
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is where this question deviates from being a 'generic' question, and becomes more specific.
but this device (an Inductor) … impedes the rapid changes in the current.
This one hit behind the barn.
First Sentence:
This device then solves the entire problem.
These are simplified answers to the original question, and does not change anything I wrote above.
At one ohm, the resistor has a maximum of 1 watt power.
In schematic diagrams this is the symbol for a fuse:
2024–10–16 [ OO OLAOYE OYEBODE ]
I post the exact comment here.
2024–10–10[John johnson John Johnson ]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It seems Mohan does not understand the difference between a comment and an Answer.
Barnstars:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
the problem then depends on "how fast does the fuse operate?".
Because the load is inductive, the current lags the voltage.(by a bit).
Upvotes:
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
but I think this circuit , shows a few more pieces.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
He then describes the function of a fuse.
what exactly is a ‘surge’ protector?
A circuit breaker is similar, but is resettable.
It also is a device that limits the change in current flow.
What is lightning?
eight
An AC voltage/ current source, and an ac inductive load.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Here is a simplified AC power diagram.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is the picture of an electronic coil of wire wound around a core of magnetic material.